Hints and tips

Need help with choosing wallpaper? Not sure how to calculate the necessary amount of wallpapers? Do not know how that kind of wallpaper glue?

Use our wallpaper counseling on e-mail: info@vavex.cz.

Types of wallpaper

Depending on the material used distinguish the following types of wallpapers:

  • paper wallpaper

    Paper wallpapers wallpapers include the printed, embossed and crimped paper. These can be both colorful patterned, smooth wallpaper, and the types referred to as corrugated, paper prepared excavation. For particularly high quality are considered two-layer embossed wallpaper called duplex.

  • vinyl wallpaper

    Vinyl wallpapers are appropriate to all types interior (walls, drywall, Formica, various washable paints). Depending on the quantity and quality of the upper layer is preferably vinyl wallpaper used for various purposes. Bathroom wallpaper can be used in wet environments, such as a bathroom and WC. Vinyl wallpapers are very good overlap capability under the crooked and cracked walls.

  • Vlies wallpaper

    This type of wallpaper is relatively new and due to simple processing enjoying increasing popularity. For the production vliesových wallpapers are used unilaterally a fiber impregnated carrier material. It consists mainly of cellulose and textile fibers, which are associated binder. This ensures maximum dimensional stability. The material also has high air permeability and water vapor.
    Another peculiarity vliesových wallpaper is that the adhesive is only applied to the wall (uniformly and not too strong) and wallpaper is added dry. Vlies wallpaper Unlike paper also require time for soaking with water.

  • Wallpaper symbols

What is needed for decorating

Before you decorate, prepare the following things. When it starts to dry wall adhesive, it is too late to hunt and preparation is therefore worthwhile.

  • wallpaper
  • Adhesive Wall Covering
  • sharp knife or scissors
  • meter
  • pencil
  • brush and brush wallpaper
  • glue pot
  • rubber roller wallpaper
  • workbench
  • ladder (steps)

Preparation before gluing wallpaper

  1. Before wallpapering check symbols that are important in the purchase and subsequent work with wallpaper. Tapetujte wallpaper always one batch!
  2. All wallpapers should have the same serial number to get the same color.

3.The surface must be flat, clean, non-greasy, free from any previous paint or wallpaper. Smooth surfaces and old paint colors is recommended to wash and rough sandpaper. Inequalities plaster repair with plaster or gypsum putty, smooth it with a spatula and after drying přesmirkujte. The highly porous and rough surfaces, apply primer. Smooth the rough stucco or wallpapered release paper Glue. 4. To remove old wallpaper use wallpaper remover Beeline. 5. Buy one role more than you calculate consumption. Will serve as a reserve for repairs. If you did not need to buy would be a hue role identical to that of the original. 6. Higher quality results if you stick surface before wallpapering release paper. 7. When calculating the roles are particularly treacherous wallpaper with a pattern, you should expect more cuts 8. If you use backing paper should be attached perpendicular to the wallpaper that the joints do not overlap. 9. Air bubbles wallpaper removed by piercing with a sharp knife. Brush inside we začistíme little glue and a brush and a damp sponge. 10. Do not use on plastic wallpaper roller, it could damage the structure of wallpapers. Press the wallpaper prefer cloth. 11. When using decorative bordures sure to mark on the wall lend a horizontal line along which you glue strips. 12. When gluing the wallpaper until it dries avoid drafts or excessive heat. The optimum temperature is 18 ° C.

Bonding wallpapers

Paper wallpaper: They are suitable for all interiors, however, are not suitable for humid environments and even the walls that much crack.

  • Base:

    The walls of the room thoroughly and align inequality, such as a spatula. Old wallpaper on the wall and remove the water soluble paint, preferably water or a wallpaper stripper or wallpaper glue diluted with water (about 1 box of 8–10 l). Other products recommended, otherwise it can soak into the new surface (yellow spots). When the surface is dry and hard, you can proceed to bonding. On fresh plaster or spatula rather prefer to apply a primer. Penetration of the substrate can also make adhesive bonding wallpapers and according to the instructions on the adhesive.

  • Number:

    Number of rolls of wallpaper is dependent on cuts wallpaper, which is listed on the label. For each nalepenému belt cuts add an.

  • Adhesive:

    For quality workmanship is paramount properly selected adhesive. If the paper wallpapers, dual layer (called duplex) or stick to the non-absorbent substrate, it is better to use a thicker adhesive and apply a thin layer than vice versa. Natírejte wallpaper and wall. Wallpaper and paint the reverse side fold upon themselves to make the glue evenly soaked into the paper wallpaper. Caution! Time to soak wallpapers is 1–2 min! If time soaking longer than recommended, wallpaper is stretched.

  • Bonding:

    belt length = room height + 5 cm allowance above and below the alignment. In the case that the paper wallpapers with pattern (requires cuts), attaches the reel so that it always followed start pattern. Hill paperhangings would rather indicate that the bonding avoid tipping strip wallpaper, but if this is not stated on the label. We do not recommend that you read the paper wallpapers forward cut it across the room, as in the case of a complaint can not complain already cut role.
    Glue the first strip from the window towards the door. First, using a plumb line, mark a vertical line. Paper wallpapers Glue side by side, just in the corners and on problem areas wallpaper can cover the holes of each other. Place the first strip to the wall and press it with your hands against the wall. That they should not air bubbles, smooth the wallpaper from the center to the edges. Margins wallpapers that go beyond the bottom, Cut cutter with a ruler. Remove glue residue quickly as possible with a clean cloth. When bonding via sockets and switches off the electric current in the actual bonding unscrew the cover, wallpaper glue and then cut out a hole. When gluing the window niches allow overlapping wallpaper and after drying it exactly Cut. For radiators wallpaper just 10–15 cm base. Ceilings prefer Glue in pairs. If you want to individually and separately adjust the skirt wall, the drying wallpaper with a pencil and ruler to mark. Use the cutter and ruler, cut the wallpaper and then remove it. Glue curbs carved into place. Do not stick paper wallpaper on the wall with the window open, the door, turn off the heating – if the water soon dries, do the wallpaper bulges.

Sticking vinyl wallpaper

Vinyl wallpaper: They are suitable for all types of interior (walls, drywall, Formica, various washable paints). Depending on the quantity and quality of the upper layer is preferably vinyl wallpaper used for various purposes. Bathroom wallpaper can be used in wet environments, such as a bathroom and WC. Vinyl wallpapers are very good overlap capability under the crooked and cracked walls.

  • Base:

    The walls of the room, carefully clean and adjust imbalances, such as sealing compound. Old interior wallpapers and remove water soluble paint. Formica and various coatings abrade and degrease well. If the surface is dry and hard, you can proceed to the bonding. Wet wall vinyl wallpaper stick, wallpaper pod can create mold. In classical prefab bathrooms increase the life of a professional sticking vinyl wallpaper. On fresh plaster or spatula, apply primer. Penetration of base you can also glue on wallpaper glue, according to the enclosed instructions.

  • Adhesive:

    For quality workmanship is paramount properly selected adhesive. If the vinyl wallpapers difficult or stick to non-absorbent surface, use a special glue that prepare the thicker consistency.

  • Bonding:

    belt length wall hangings = room height + 5 cm allowance above and below the alignment. In the case that the vinyl wallpapers with a pattern (it is necessary cuts) attaches to the roll so that it always followed start pattern. Hill vinyl wallpaper you prefer a pencil, while sticking to avoid tipping strip wallpaper, but if this is not stated on the label.
    Glue the first strip from the window towards the door. Advance using a plumb line, mark a vertical line. Vinyl wallpapers Glue side by side, just in the corners and on the problem areas you can cover the holes of each other. Apply adhesive to the wallpaper and the base vibrator roller. Painted wallpaper contact adhesive on the reverse side and fold over themselves to glue evenly soaked into the wallpaper. Caution! The time needed to soak vinyl wallpaper is 5–7 min. If time soaking longer than recommended, wallpaper is stretched. Forward to Prepare max. 1–2 strips. Make sure that the duration of action of wallpaper glue was the same for all coated belts. Place the first strip to the wall and push it hands to the wall. To avoid air bubbles, smooth the wallpaper from the center to the edges tapetovacím brush, whose light tapping with seams together. Margins wallpapers that go beyond the bottom, Cut using a ruler to trimming knife. Remove glue residue quickly as possible with a clean cloth. When sticking around sockets and switches off power. current, the self-adhesive unscrew the cover, wallpaper glue and then cut a hole. When gluing the window niches have overlapping wallpaper and after drying it just cut off. For radiators wallpaper just 10–15 cm base. Ceilings Glue instead of two. When gluing vinyl wallpaper formica is good to mix glue white glue. When renovating bathrooms and shower enclosures is suitable for gluing each joint podmazat clean dispersions (eg Duvilax LS50) and in places particularly exposed joints fill with clear silicone sanitary. This investment will greatly vyplatí.Vanu, sink or shower with suitable seals. If you want to individually and separately adjust the skirt wall, drying wallpaper using pencils, rulers and special nože.Pokud you individually and separately adjust wall border, on the dry wallpaper with a pencil and ruler to mark where you want it to stick. The top layer using a special knife to cut and glue the curbs in place so cut. Do not stick vinyl wallpaper on the wall with the window open and the door and turn off the heating. If the water dries up early, make the wallpaper bulges.

  • Check before wallpapering:

    Check each series, pattern and color wallpapers. Find out if you purchased carpeting wallpapers sufficient for the papered room. Until then unpack vinyl wallpaper from the film. Compare the color vícerých roles with each other. Do not cut all the parts at once, but gradually. You can claim only the role.

Bonding vliesových wallpapers

Vlies wallpaper: They are suitable for all materials, walls, walls, ceilings, etc., equipped with all kinds of interior plaster, plasterboard, the concrete panels, background wallpaper, chipboard, etc. Especially suitable for walls with cracks in the substrate, stabilize pressure sensitive materials (plates made ​​of soft fiber, etc). The advantage of non-woven wallpaper from fibrous pulp is perfect breathability.

  • Base:

    The walls of the room, carefully clean and adjust imbalances, such as sealing compound. Old wallpaper and painting to remove water soluble. If the surface is dry and hard, you can proceed to bonding. Fresh plaster, plaster, drywall and all absorbent substrates obtain better penetration. Penetration of base you can glue to glue wallpaper, according to the enclosed instructions. Damp substrates are not suitable. Also, if the substrate is significantly different colored or patterned, it is better to be primed in textured wallpaper. If you over-painted wallpaper, the background color can be different.

  • Adhesive:

    For bonding is necessary to use special glue for non-woven wallpaper.

  • Bonding:

belt length Vlies wallpapers + = room height 0.05 m allowance at the top and bottom of the waste. In the case that the non-woven wallpaper with a pattern, attaches the reel so that it always followed start pattern. Hill Vlies wallpaper you prefer a pencil, to avoid sticking to the roll strip wallpaper.
first strip glue from the window towards the door. Advance using a plumb line, mark a vertical line. Vlies wallpapers Glue side by side, just in the corners and on the problem areas you can cover the holes of each other. When bonding through outlets and switches off power. current, the self-adhesive unscrew the cover, wallpaper glue and then cut. When gluing the window niches have overlapping wallpaper and then it just cut off. The radiator just wallpaper 10–15 cm base. Ceilings prefer Glue in pairs. Apply the adhesive to the wall or wallpapered surface (according to the manufacturer's in­structions) vibrator roller. Dry strips cut non-woven wallpaper wind up facing inward, resulting roll of adhesive to attach the painted walls, wallpaper and unwind when pressing on the wall with a rubber roller. Margins wallpapers that go beyond the bottom, cut with a knife-edge. Remove glue residue quickly as possible with a clean cloth. If you want to individually and separately adjust wall border, on the dry wallpaper with a pencil and ruler to mark where you want it to stick.

Consumption calculation wallpapers

See wallpaper calculator

© 2010 - 2018 VAVEX | Ochrana osobních údajů | Cookies

Developed by: Smartim

Tento web používá k poskytování služeb, personalizaci reklam a analýze návštěvnosti soubory cookie. Používáním tohoto webu s tím souhlasíte. Více informací >